Tightening Torques; Troubleshooting - Chicago Pneumatic CP 1260 Sicherheits- Und Bedienungsanleitung

CP 1210, CP 1260, CP 1290

Tightening torques

Fitting claw couplings or other connectors
NOTICE When fitting a claw coupling or other
connectors to the swivel, Loctite® 263™(Loctite is a
registered trademark of Henkel Corporation. 263 is
a trademark of Henkel Corporation) or similar has
to be used.
Tightening torques CP 1210
CP 1210
A. Torque: 19 lbf.ft (26 Nm). Apply Loctite®
242™(Loctite is a registered trademark of
Henkel Corporation. 242 is a trademark of
Henkel Corporation).
Torque: 70 lbf.ft (95 Nm).
B.
The cylinder seal must protrude approximately
C.
1 ⁄ " (1.6 mm) before assembly of the back
16
head.
D. Torque: 150 lbf.ft (200 Nm). Apply Loctite®
263™(Loctite is a registered trademark of
Henkel Corporation. 263 is a trademark of
Henkel Corporation).
Torque, Muffler (not illustrated) 6–7 lbf.ft
E.
(8–10 Nm).
Assembled length of spring or buffer.
F.
Model
CP 1210
Tightening torques CP 1260 and CP 1290
9800 1351 90 | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
A
B
C
D
F
Min-Max length
in. (mm)
1.66 –1.72 (42.1–43.7)
Safety and operating instructions
CP 1260 and CP 1290
A. Torque: CP 1260 and CP 1290, 100 lbf.ft (135
Nm).
The cylinder seal must protrude approximately
B.
1 ⁄ " (1.6 mm) before assembly of the back
16
head.
C. Torque: 150 lbf.ft (200 Nm). Apply Loctite®
263™(Loctite is a registered trademark of
Henkel Corporation. 263 is a trademark of
Henkel Corporation).
Torque: 75 lbf.ft (100 Nm).
D.
Torque, Muffler 6–7 lbf.ft (8–10 Nm).
E.
F. Assembled length of buffer.
Model
CP 1260
CP 1290

Troubleshooting

If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
A
B
C
E
F
D
Min-Max length
in. (mm)
2.14 –2.19 (54.4–55.6)
2.55 –2.61 (64.8–66.2)
21