Technical Specifications - Metabo W 18 LTX 115 Quick Originalbetriebsanleitung

Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-
circuiting (e. g. by protecting them with adhesive
tape).

14. Technical Specifications

Explanation of details on page 2 . Subject to
changes serving technical progress.
U = Voltage of battery pack
D = max. diameter of accessory
max
t = max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (17)
t = max. permitted thickness of clamping
max,2
shank on accessory when using
"Quick"clamping nut
(2)
t = grinding wheel / cut-off wheel:
max,3
max. permitted thickness of
accessory
M = Spindle thread
l = Length of the grinding spindle
n = No-load speed (maximum speed)
P = Nominal power input
1
P = Power output
2
m = Weight (with the smallest battery pack)
Measured values determined in conformity with
EN 60745.
Direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value (sanding
h, SG
surfaces)
a = Vibration emission value (sanding with
h, DS
sanding pad)
K =Uncertainty (vibration)
h,SG/DS
Typical A-effective perceived sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
ENGLISH en
19