Respekta CH 66038-60 S Installations & Bedienungsanleitung Seite 22

English
Comply with safety distance between hob and hood.
1. Clean the environment thoroughly prior to installation in order that no dust or building waste can be drawn in.
2. The exhaust air hose must not be routed through a shaft together with gas pipes, hot air air pipes etc.
3. The exhaust air hose must be routed as straight as possible away from the hood or with a maximum bend outwards of 120° and
fixed to the external wall.
4. To avoid grease accumulations in corners, on installation make sure that the hood hangs horizontally.
A Circulating air filter mode
B Exhaust air mode
Attention! Install carbon filter (A1) only with circulating
air mode
A Circulating air filter mode
Same procedure as described under the following
chapter B. without step 5. & 6. However, omit step 2.
in addition fit the carbon filters) (Fig. A1) before
mounting the grease filter 2a
B Installation for exhaust air mode
(B1)
Via an exhaust air shaft through the house roof
(B2)
Laterally through the house wall to the outside.
Before starting the installation, please remove the
grease filter 2a and then proceed as follows:
1.
Drill the 8 mm holes in the wall by using the drill
template 1and insert dowels.
2.
Turn the screws up to approximately 10 mm into
the plugs (see 2b)
The wall plugs supplied with the appliance are
for solid masonry only.
3.
Fix the nozzle 3a
4.
Hang the hood onto the screws and tighten the
screws firmly.
5.
Attach the hose 3b to the exhaust nozzle 3a
6.
Lay the hose to its final position see 6a / 6b)
7.
Drill 2 holes for the bracket 7a, set the dowels
and fix the bracket on the wall
8.
Fix the chimney shaft 7b together with the
telescopic shaft 7c on the hood, slide out the
telescopic shaft up to the ceiling and fix it on the
bracket 7a with screws. (7e)
9.
Plug in the appliance
10.
Insert the grass filter 2a
fi140430XBNEG
Operating instructions / users manual Cooker Hoods
16. Installation Instruction
Cooker Hoods
See chapter 11.1
Min. 650mm
2a
3a
7a
10
A
B
8 mm
2b
3a
3b
7c
7b
Figures are for illustration purposes only.
GB
6a
6b
7e