Operation With Mfx - Märklin 76472 Bedienungsanleitung

CV Meaning
33 Numer of output
addresses
40 Meaning Lighting
PoM*
45 Home signal
76471/76472
PoM*
76491
76493
76494
48 Switching duration
LED on/off
PoM*
50 Cross fading behavior
*PoM programming can be done on the main track as long as it
is supported by the control device.
Setting and Calculating Addresses Greater than 255 (DCC):
Example: Address 1044 -> 1044 : 256 = 4.078125. The value before
the decimal point (4) is entered in CV 9. The value after the
decimal point (0.078125) is multiplied by 256 0.078125 x 256 = 20.
The calculated value of 20 must be entered in CV 1.
Values
read only DCC
0 - 15 (15) 0 light off
Dimming 0-15,
whereby 15 = 100%
brightness
1 Track block / yard signal
2 Block signal
3 Entry signal
4 Exit signal
0 - 3 0 = 0 seconds
1 = 0.175 seconds
2 = 0.35 seconds
3 = 0.5 seconds
0 - 3 0 = simultaneously
1 = one after the other
2 = one after the other
0.1 sec. pause
3 = one after the other
0.5 sec. pause

Operation with mfx

mfx registration can be done with MM or DCC.The mode of ope-
ration that has been set by means of Dip Switch 10 is critical.
The mfx registration is initiated with the 60213/60214/60215 CS2
in > and with the 60216/60226 CS3 in the solenoid item
configuration by means of
Note about mfx registration with the CS2:
Selection possibility „Automatically assign solenoid item" at
„Setup" > > „Track".
If the check mark there is checked, the mfx registration is done
at the first open address in the CS2. If the check mark is not
checked, the mfx registration is done at the address actually
programmed on the decoder.
>"search for mfx item".
11