Cleaning And Maintenance; Co Bottle Replacement - clage Zip HydroTap G5 BCS 60 Gebrauchs- Und Montageanleitung

7. Cleaning and Maintenance

A
B ( 2 : 1 )
7 6 5
7 6 5
CO
2
B
The gas pressure of the carbon dioxide gas bottle can be read on manometer 'A'. If the
gas bottle is empty, replace it as follows:
1. Close the red lever '1' on the pressure reducer.
2. Turn the pressure adjusting screw '2' on the pressure reducer anticlockwise as far
as it will go (no pressure).
2
3. Replacing the carbon dioxide gas bottle.
a. Gas bottle with self closing valve:
1
4 3 2
b. Gas bottle with hand wheel:
Gas bottle with
self closing valve
4. Set a outlet pressure 'B' of 3 bar on the pressure reducer:
a. Gas bottle with self closing valve: To adjust the outlet pressure 'B' use the
b. Gas bottle with hand wheel: Open the hand wheel valve at the CO
Gas bottle with
hand wheel
DATUM Name
Gezeichnet 16.07.2014 ruecker
5. Open the red lever on the pressure reducer.
Kontrolliert
Norm
6. Check the gas-carrying connections for leaks. Caution - gas released can be very
Status Änderungen DATUM Name
4 3 2
cold. Use a leak detecting spray or soapy water so that even minor leaks will be
detected.
Note: The that the room where a carbon dioxide gas bottle is placed must have a
minimum room volume of 17 m
bottle and an assumed room height of 2.2 m you will need at least 7.7 m² floor area.
Note: The carbon dioxide gas bottle must always be used in the upright position
to ensure that the pressure reducer operates correctly and thus ensure the safety
of the unit!
Note: The carbon dioxide gas bottle must not be exposed to temperatures higher
than 35 °C! Cooling should be provided if necessary.
Bottle Replacement
- Unscrew the gas bottle from the pressure reducer.
- Quickly screw the new, full gas bottle into the pressure reducer, as far as it will
go.
1
- Secure the new gas bottle in place on the holder so that it cannot topple over.
F
- Close the shut-off valve on the gas bottle.
- Undo the union nut connecting the gas bottle to the pressure reducer.
E
- Remove the gas bottle and secure the new gas bottle in place on the holder so
that it cannot topple over.
- Connect the pressure reducer to the new, full gas bottle. Tighten the union nut
D
moderately tight.
C
adjusting screw '2'. Turn it anticlockwise to reduce the pressure. Turn it clockwise
to increase the pressure.
B
adjust the outlet pressure 'B', use the adjusting screw '2'. Turn it anticlockwise to
reduce the pressure. Turn it clockwise to increase the pressure
A
1
Zeichnung Gasflaschenkopf
A2
1
3
37
for every kg of bottle capacity. At a one-kilogram
CLAGE
EN
-bottle. To
2