ECG TK 1510 Bedienungsanleitung Seite 35

convector may be higher while it is in operation than usual. Place
the convector to ensure su cient air circulation.
9. Do not place the convector on a high pile carpet.
10. Do not place the convector in front of or directly under an electric
socket.
11. Do not cover the heat convector! In case of covering it there is a risk
of overheating of re.
12. The convector must not be connected to the electrical outlet via
a timer or connected to a remote switching power circuit, as in
the case of remote switching on the covered or incorrectly placed
convector there is a risk of re.
13. Do not use the convector close to a bathtub, shower or a pool
and do not place it in locations where is a danger of it falling into
a bathtub or another container with water!
14. If the device emits an abnormal smell or smoke, immediately unplug
it and have it checked by a service centre.
15. Do not switch o the device by pulling on the power cord. Always
turn o the main switch of the convector rst!
16. Always unplug the convector when moving it to another location.
17. Do not leave a convector with inserted power cord unsupervised.
Disconnect the cord from the electrical outlet prior to any
maintenance. Do not unplug the device by pulling the power cord.
Unplug the power cord from the outlet by grasping the plug.
18. Do not allow the power cord to touch hot surfaces or run the cord
over sharp edges.
19. Do not use the convector in places where ammable materials
are stored (paint, gasoline, solvent etc.) or where there is a risk of
ammable fumes appearing.
20. Do not put your ngers or other objects into the openings of the
heat convector.
21. Do not cover the output vents by e.g. a towel or dry any laundry on
it.
GB
35