Flex VCE 45 M AC Bedienungsanleitung Seite 18

Removing the dust disposal bag
Illustration
 Release and remove the suction head.
 Put the disposal bag over.
 Pull the opening of the disposal bag out
toward the back over the suction sup-
port and seal it tightly.
 Tightly seal the disposal bag with clo-
sure strips underneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according
to the local provisions.
 Insert and lock the suction head.
To suck wet dirt, always remove the dis-
–
posal bag.
General
Warning
The flat pleated filter must must always be
in place while vacuuming.
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle (option) or if wa-
ter is sucked up from a container it is
recommended to deactivate the "auto-
matic filter dedusting" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
18
Turning on the Appliance
 Plug in the main plug.
 Switch on the appliance at the main switch.
Adjust the suction output
 Set the suction output (min - max) at the
rotary switch.
Working with electrical power tools
Danger
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.
 Connect the mains plug of the electric
power tool to the vacuum cleaner.
 Switch on the appliance at the main
switch.
Indicator lamp is on; vacuum cleaner is in
the standby mode.
Note: The vacuum cleaner is turned on and
off automatically with the electric power tool.
Note: The vacuum cleaner starts automatically
within 0.5 seconds and continues to run for 15
seconds after the power tool has being
switched off.
Note: Please refer to "Technical specifications"
for the power connection specifications of the
power tools.
Illustration
 Adjust the stepped power tool adaptor to fit
the connection of the electric power tool.
Illustration
 Attach the stepped power tool adaptor to
the suction hose.
Illustration
 Connect the adaptor to the electric power
tool.
Note: The different suction hose sections are
required to allow an adjustment to the con-
nection sections of the processing tools.
 Set the minimum volume flow for the
suction hose cross section at the rotary
switch.
The scale displays the suction hose cross
section.
4
-
EN
Operation