VOLTCRAFT SEM5000 CH Bedienungsanleitung Seite 92

Pressing the R button clears the settings and returns to the
normal display.
Briefly press the
day (flashes on the display).
Use the button
ment days from "00" to "07".
Briefly press the
setting.
Use the button
ment hours from "00" to "23".
Briefly press the
display shows no other flashing values.
2. Starting the measurement
Proceed to set the measurement period (see chapter
9.14/1.). The example shows a measurement period of
3 days.
When the display is not flashing, briefly press the
button to start the measurement.
The
back to the measured
values. During the auto-
matic measurement, the
display shows the flash-
ing PERIOD (see arrow
in the figure on the right).
92
or
or
display changes
button to proceed with setting the
to set the number of measure-
button to continue with the hour
to set the number of measure-
button to exit the setup menu. The