VOLTCRAFT SEM5000 CH Bedienungsanleitung Seite 82

– CO
2
– Overload alarm limit
– Standby limits
– Setting the time
Proceed to the next step if you have set the overload alarm
(see chapter 9.8) before setting the delete mode.
Or access the setup mode, as described in chapter 9.2.
Press the
next step).
The display shows CLr. Briefly press the
CLr dAtA at the bottom of the display.
Use the buttons
functions CLr dAtA and CLr SEt.
A letter "h" appears in front of the data you want to delete.
Press and hold the F button for 3 seconds until you hear a beep
to delete the selected data. The selected data is deleted. The
display shows CLr again.
Briefly pressing the
deleting any data. The display shows CLr.
When the display is not flashing, briefly press the
return to the beginning of the setup mode or briefly press the
button to leave the setup menu.
82
emissions per kWh (kg/kWh)
button six times to enter the delete mode (see
and
button cancels the delete mode without
button to access
to select either of the delete
button to