Installation Regulations - Novy 1851 Easy Montageanleitung

2. INSTALLATION
Before installation read the general information and safety
regulations (see chapter 1). Mounting shall only be carried
out by authorised experts. The user has to observe the
laws and standards of the country of residence.

Installation regulations


The distance between the cooking plate
and the wall must be min. 55 mm.
− The cooking plate belongs to protection class « Y ».
When built in, there may be a high cabinet side or a
wall on one side and at the rear. On the other side
there may be no piece of furniture or unit higher than
the cooking surface.
− Min. 650 mm between work surface and top cupboard.
− The strips on the wall edges must be heat-resistant.
− Do not mount the unit above a dishwasher, oven,
cooling units or a washing machine or dryer.
− Make sure there is a distance of 20 mm below the
casing of the unit for proper ventilation.
− Do not store any flammable and not heat-resistant
objects in the drawer below the cooking plate (e.g.
sprays).
− There may be absolutely no mechanical tension on
the connection cable, such as a drawer.
3. INSTALL THE EXHAUST DUCT
(ONLY 1861)
The motor outlet has a rectangular exhaust of 220 x
90 mm. It is recommended to connect an exhaust duct
to this with the same dimensions.
For optimum performance of the hood it is important to
pay attention to the items mentioned below.
General:
− Make the duct as short as possible and with as few
as possible bends to the outside.
− Avoid square bends. Use rounded bends for proper
air conduction.
− If an exhaust pipe through the outside wall passes
a cavity wall, make sure that the exhaust duct fully
bridges the cavity and slightly declines to the outside.
− In case of an exhaust pipe through the roof, use a
double-walled roof passage with sufficient width.
− Never connect the exhaust to a flue duct.
− Make sure that sufficient air is supplied. Fresh air can
be supplied by slightly opening a window or an outside
door or by installing an inlet grate.
4. RECIRCULATION INSTALLATION
(ONLY 1861)
With recirculation, a return opening of at least 550 cm²
must be provided in the kitchen furniture in order to blow
the cleaned air into the kitchen.
The return opening can be made by making a cut-out in
the plinth or by fitting a grille.
The air outlet can be provided by using the connection
adapter. This ensures the return of the air through a recess
in the back wall. The gap between the back panel and an
adjacent piece of furniture or wall must be at least 25 mm.
Another solution is to use the Novy Easy recirculation
kit. The return airflow is then made possible directly in
the plinth.
For optimum performance of the hood it is important to
pay attention to the items mentioned below.
General:
− Make the duct as short as possible and with as few
as possible bends.
− Avoid square bends. Use rounded bends for proper
air conduction.
7