en
Operation
Warning!
Do not twist the cord when inserting it. If the
appliance features an automatic cord winder,
do not insert the cord manually. If the cord
jams, pull out the cord all the way and then
allow it to wind up.
■ Insert the mains plug.
Bowl and tools
W Risk of injury from the rotating tools!
While the appliance is operating, never place
fingers in the mixing bowl. Attach the cover
(12) before operating the appliance!
Do not change tools until the drive has
come to a standstill – when the appliance
is switched off, the drive continues running
briefly and stops in the tool change position.
Do not move the swivel arm until the tool has
come to a standstill.
Always secure unused drives with protective
drive covers.
Attention!
Use bowl with this appliance only.
Stirrer (13)
for stirring dough, e.g. cake mixture
Whisk (14)
for whisking egg whites, cream and
light dough, e.g. sponge mixture
Kneading hook (15)
for kneading heavy dough and
mixingin ingredients that ought not
be cut (e.g. raisins and chocolate
chips)
Working with the bowl and the tools
Fig. E:
■ Press the Release button and
move the swivel arm to position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set
it down. Turn anticlockwise until it locks
into place.
■ Depending on the processing task, insert
the stirrer, whisk or kneading hook until it
locks into position.
22
All manuals and user guides at all-guides.com
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig. E-4b).
■ Put the ingredients to be processed into
■ Press the Release button and
■ Attach the cover.
■ Set the rotary switch to the desired setting.
Our recommendation:
– Stirrer:
– Whisk:
– Kneading hook:
Adding more ingredients
■ Switch off the appliance with the rotary
■ Add more ingredients through the feed
or
■ Remove lid.
■ Press the Release button and
■ Add ingredients.
After using the appliance
■ Switch off the appliance with the rotary
■ Remove mains plug.
■ Remove lid.
■ Press the Release button and
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see "Cleaning and
Continuous-feed shredder
W Risk of injury!
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuousfeed shredder, wait until the
drive has come to a standstill and pull out the
mains plug. Do not reach into the feed tube.
the bowl.
move the swivel arm to position 1.
first stir in at setting 1 (1), then select
setting 7 (4)
setting 7 (4), mix in at setting 1 (1)
first stir in at setting 1 (1), knead at
setting 3 (2)
switch.
tube in the cover.
move the swivel arm to position 2.
switch.
move the swivel arm to position 2.
servicing".