Safety Information - Renkforce 449238 Bedienungsanleitung

5. Safety Information

The guarantee/warranty will expire if damage is incurred resulting from non-compliance with these
operating instructions. We do not assume any liability for consequential damage!
Nor do we assume any liability for damage to property or personal injury caused by improper use
or failure to observe the safety information. The warranty/guarantee will expire in such cases!
Dear customer, the following safety information is intended not only for the protection of your health but also
for the protection of the device. Please read the following items carefully:
• The unauthorized conversion and/or modification of the product is prohibited for safety and approval
reasons (CE). Never open/dismantle this product! There are no interior components to be set or serviced
by you.
• This product is not a toy and not suitable for children. Operate it out of the reach of children.
• Mains adapter setup corresponds to protective class I. Only a proper protective contact mains socket
must be used as voltage source.
The mains socket must be close to the device and easily accessible.
• The product is only designed for use in dry, enclosed inner rooms; it must not become damp or wet.
Never touch it with your bare hands! There is danger to life from electric shock!
• Protect the product from direct solar radiation, strong heat or cold, dust and dirt, vibrations or mechanic
load. Handle the product with care; impacts, shock or fall even from low heights will damage it.
• If the product is brought from a cold into a warm room (e.g. for transport), it is possible that condensation
develops.
Therefore, first let the product reach room temperature before connecting it to the power supply. This
may take several hours. There is danger to life from electric shock from the mains unit otherwise!
• Do not pull the mains plug from the mains socket by pulling the cable.
• If the mains adapter or mains cable are damaged, do not touch it. Danger to life from electric shock!
First deactivate all sides of the mains socket to which the mains adapter is connected (e.g. switch off the
respective fuse or turn out the fuse. Then deactivate the associated FI protection switch). Only then pull
the mains plug from the mains socket and take the product to a specialist workshop.
• It can be assumed that safe operation is no longer possible if:
- the device shows any visible damage,
- the device no longer works
- the device was stored under unfavourable conditions for an extended period of time
- if it was subjected to heavy stress during transport
26