Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Transportation
Driving
To manoeuvre or get across short
distances.
Start the machine.
•
Select a forwards or reverse gear.
•
Press coupling lever for driving
•
system/coupling bar and hold it
down.
Maintenance
Maintenance schedule
Once in the season:
Have the machine checked over and
maintained in a specialist workshop.
Maintenance tasks
Clean throw-out chute, worm and worm casing
Clean air filter
Replace air filter
1
)
Change oil (STH 5.56, STH 8.66, STH
10.66 C)
3
)
Lubricate mobile and rotating parts
Clean spark plugs
1
)
Have spark plugs changed
Check tyre pressure, increase as required
Clean air cooling system and exhaust
Check coupling adjustment, readjust as
required
Have the carburettor setting checked
Inspect the clearing plate, replace worn-out
clearing plate
Check skids, replace worn-out skids in pairs
Check caterpillar track, readjust as required.
Replace defective caterpillar track
Replace fuel filler cap
Have exhaust silencer replaced
)
See "Engine instructions"
1
2
)
Have this work carried out only by a specialist workshop
3
)
First oil change after 5 hours
4
)
Oil change every 25 hours of heavy work
22
Move the machine carefully.
•
Transporting the machine
without it operating from its
own power
Risk of injury
!
Before transportation
– Turn off the engine.
Each time before using the
machine:
Check the oil level and top up as
necessary.
After use
2
)
1
)
2
)
2
)
10 h
25 h
•
•
•
l
Operating Manual – Snowthrower
– Remove the ignition key and the
spark-plug connector.
– Wait until the engine has cooled
down.
Transport the machine on or in a
•
vehicle in a horizontal position.
Secure the machine against rolling
•
or slipping.
Check all screw fittings for firm
seating, tighten them if necessary.
Check the safety features.
50 h
End of
As
season
required
•
4
)
•
•
•
•
•
•
•
•
•
•
•
•
Werbung
Inhaltsverzeichnis
