Silvercrest SHBS 3.7 A1 Bedienungsanleitung Seite 20

BB.5$ B%ERRN 6HLWH  0LWWZRFK  'H]HPEHU    
DANGER from batteries!
~ Ensure that the battery is not damaged as you remove it.
Fire hazard!
~ The removed battery must not be disassembled.
~ Never short-circuit the battery. The contacts on the re-
moved battery must not be connected by metallic objects.
The battery may overheat and explode.
~ Only remove the battery to dispose of the device. The de-
vice is destroyed by removing the battery. Never try to op-
erate a disassembled device.
1. Disconnect the device from the mains.
2. Switch on the device and let it run until the battery is empty.
3. Figure A: remove the attachment|12,|3,|4,|11,|13 from
the hair and beard trimmer|5 by pressing it with the thumb
towards the rear.
4. Figure D: use a Phillips screwdriver to release the
3 screws on the back and on the top end of the device.
5. Figure E: use a screwdriver to lever open the side seam
and unfold the two halves of the housing apart.
6. Figure F: release the 3 screws on the board and turn it so
that the battery faces you.
7. Figure G: release the connections between the battery and
the board with a pair of pliers/wire cutters. Remove the ex-
posed battery. Take the battery and the device separately to
suitable disposal.
The lithium-ion battery used for this device
may not be treated as household waste. The
battery must be disposed of properly. Con-
tact battery distributors or local waste dispos-
al points for this.
18 GB
Li-ions