Machine Overview; Controls; Setup; Receiving And Unpacking - IGM LAGUNA Fusion3 Gebrauchsanweisung

Dusk mask should be worn.
Eye protection should be worn.
Ear protection should be worn.
Disconnect from power supply before
servicing
Fully read manual and safety
instructions before use.
Safety gloves should be worn.

5. Machine Overview

1. Start / Stop
2. Rip Fence
3. Fence Front guide
4. Fence Rear guide
5. Table with mitre slots
6. Cabinet with integrated mobility kit
7. Arbor height adjustment control
8. Arbor tilt adjustment control
9. Dust extraction outlet
10. Moror cover
11. Throat plate
12. Blade
13. Blade guard
14. Riving knife
15. Arbor wrench
16. Push stick
17. Mitre gauge
Pic. 5
www.igmtools.com

5.1 Controls

Start/Stop/Fuse
Pic. 6
1. Magnetic switch
2. Overload protector
3. Fuse
CAUTION: Always turn off and unplug the
machine before changing the fuse.
Arbor height control
Pic. 7
The arbor height control adjusts the height of
the blade. Centred in the control is the height
adjustment lock. Behind the control is the tile
gauge. CW to raise, CCW to lower blade.
CAUTION: DO NOT ADJUST HEIGHT WHEEL
WHEN LOCKED.
Arbor tilt control
Pic. 8
The tilt control, located on the right of the
cabinet, adjusts the tilt of the arbor. Centre is
-7-
the tilt lock. CW to tilt left, CCW to tilt the blade
to the right.
CAUTION: DO NOT ADJUST TILT WHEEL
WHEN LOCKED.
Fence clamp lock
Pic. 9
The fence clamp securely locks the fence
anywhere on the rail by a cam action
mechanism.

6. Setup

Use Caution: Your new Laguna Tools machine
is heavy. Use a minimum of two people when
lifting the tool into position and moving the tool
into position.
Warning: DO NOT connect to a power supply
until the setup is complete. DO NOT perform
any of the following steps, installations, or
adjustments with the saw connected to the
power source.
Warning: To avoid set-up problems, to prevent
potential damage to the machine and personal
injury, read through the entire setup section
prior to setting up the machine.

6.1 Receiving and unpacking

If any damage has occurred because of
shipment, note the damage on the bill of lading
or refuse the shipment. Immediately call the
dealer store where the machine was purchased.
TRANSPORTATION AND STORAGE. The
measures of anti-rust and shockproof should
be taken during packing. The machine endures
transportation and store in -25~55°C ambient
temperature.
Be careful not to expose the machine to rain or
damage when transporting or storing.
While transporting or handling the machine,
be careful and let the activity be done by
qualified personnel especially trained for
this kind of activity!
While the machine is being loaded or
unloaded, make sure that no person or
subject gets pressed by the machine!
Select proper transportation device
according to the weight of the machine.
Make sure the lifting capacity of
transportation device is competent for the
weight of the machine.
TRANSPORTATION BEFORE UNPACKING
As standard, the machine is packed in a robust
wooden box. Pic.10 shows the tool that can be
used to transport the packaging.
Pic. 10
UNPACKING
1. Receive your table saw.
2. Unscrew the crate fasteners.
3. Lift crate off pallet.
4. Check Inventory.
5. Wipe off protective oils.