Push Block And Push Stick; Type Of Cut; Ripping - IGM LAGUNA Fusion3 Gebrauchsanweisung

blades specified on the riving knife. To adjust
the position of the blade safety attachments,
relative to the saw blade: NOTE: if the cam
action lever does not lock or is too hard to lock
– adjust the nut on the back side of the cam
action axil. You will need to remove the motor
cover.
Pic. 76
Loosen the two middle setting bolts. These
two bolts fasten the assembly in-between the
set screws and the arbor block.
Pic. 77
Adjust the set screws as needed to correct
an out of align blade attachment. Do small
adjustments and check.
Pic. 78
As Adjustments are made, the blade
attachments will translate, not rotate, by design.
This ensures that the workpiece will not get
held up. CHECK COMPONENTS BEFORE
EVERY CUT.
Riving Knife Adjustments::
After changing a saw blade, always check that
the riving knife is correctly set!
The distance of the riving knife from the gear
rim must be between 3 mm and 8 mm.
The highest point of the riving knife must be set
at least 2mm beneath the topmost tooth.
The riving knife must be at least 0.2 mm thicker
than the main saw blade.
Check that the saw blade clamping system is
tight before operating the machine!
www.igmtools.com
Pic. 79
Pic. 80
Dust Collector:
Pic. 81
There is a 100 mm dust outlet located on
the lower left of the saw cabinet allowing for
the connection to a dust collection system
(not included). Air current speed is 20m/s for
vacuum suction dust emission index. When
air current speed of dust collector device (in
accordance with EN 12779:2004+ A1:2009) is
not lower than 20m/s, ensure machine can be
normal exhausted. User must wear dustproof
mask.
1. Fit the 100 mm dust hose over the dust port,
(not included) and secure in place with a hose
clamp.
2. Make sure the hose could not come off.
3. Required air flow: 934 m3/h
4. Ensure pressure drop of each dust collector
outlet carrying air current speed: 1500Pa
5. Wind speed of dust collector tube m/s: dry
chips: 20m/s, water content is equal to18% wet
chips: 28m/s.
Warning: Always turn on the dust collector
before starting the saw and stop the saw before
turning off the dust collector.
Note.: A tight fit is necessary for proper
performance.
Warning: Always turn off the table saw before
removing any cover of the machine.
-14-
Pic. 82
Remove the side cover, to clean and remove
dust, debris from dust hood.
Pic. 83

7.5 Push block and push stick

A push block (Pic.2) and A push stick (Pic.3)
must be used.
Pic. 84
Pic. 85
If the workpiece is less then 12 0mm, you must
use the push stick to prevent your hands from
getting too close to the saw blade.
Push block must be used to cut narrow
workpieces and, when necessary, to push the
workpiece against the fence, a push block can
be easily made by the operator as Pic.2.
Warning: Use only the push stick provided by
the manufacturer or constructed in accordance
with the instructions. This push stick provides
sufficient distance of the hand from the saw
blade.
Warning: Never use a damaged or cut push
stick. A damaged push stick may break causing
your hand to slip into the saw blade.

8. Type of Cut

Warning: Always wear safety glasses, a
respirator and hearing protection when
operating this machine.
Note: This saw is only designed to cut wood.

8.1 Ripping

Pic. 86