Table Adjustments - IGM LAGUNA Fusion3 Gebrauchsanweisung

Use a hex key to adjust
Pic. 55
Use the included hex key to adjust the depth of
each nylon support. Do small increments and
check.

7.2 Table Adjustments

Adjusting the Table to be Parallel with the
Blade: It is good practice to make sure that the
table is always parallel to the blade by checking
it often. You can do this with a combination
square or with a dial indicator on an appropriate
mount. Check the IGM website for these tools.
Good
Pic. 56
Combination Square. Notice: This method may
leave scratched.
Better
Pic. 57
A dial indicator on a mitre gauge.
Best
Pic. 58
A dedicated saw dial indicator. Such as this one
by 'Iagging'.
1. Un-plug the tablesaw!
2. Take initial measurement.
www.igmtools.com
Pic. 59
WARNING: MAKE SURE SAW IS
UNPLUGGED. With the throat plate and all
attachments removed, raise the blade to the
highest position at 90 degrees with the table.
Take an initial measurement about 1 cm from
the ground edge of the blade as shown.
3. Take relative measurement
Pic. 60
Keep the mitre gauge against the left rail
and slowly move crossed the blade. Take
the second measurement and compare with
the initial measurement. Adjust the table to
compensate false measurements. There are 3
bolts to loosen prior to adjusting the table, see
step 4.
4. Loosen the three table fastener bolts.
5. Adjust as needed.
Loosen Table Bolts
Pic. 61
Locate and loosen right side table to cabinet
bolt (above the tool holder).
Loosen Table Bolts
Pic. 62
Locate and loosen left side table to cabinet bolt
(above the motor cover).
-12-
Loosen Table Bolts
Pic. 63
Locate and adjust the rear table to cabinet bolt.
Adjusting or Installing Extension Wings: (may
be pre-installed):
To install or remove the extension wings, an
advised method is provided. This method
makes it easy to make the extension wings flat
with the table but requires the use of two ridged
supports and four clamps.
1. Unplug the table saw!
2. Clamp supports to table.
3. Place extension wing on supports.
4. Join or adjust the wing with supplied bolts.
Note: The clamps may scratch the tabletop!
Use a cloth or soft wood between
the clamp and the iron surfaces.
2. Take initial measurement
Pic. 64
WARNING: MAKE SURE SAW IS
UNPLUGGED. Clamp two wooden supports
to the underside of the table saw as shown.
Straight 2x4 lumber will work
3. Take relative measurement
Pic. 65
Place the extension wing on the supports and
place into position.
4. Join or adjust wing
Pic. 66
You will need (4) m10 bolts and (4) washers to
fasten each extension wing to the table top. Be
sure to align the extension wing to the table top
prior to tightening the bolts.