Releasing The Lashing Strap - Powerfix Profi HG00921A Bedienungs- Und Sicherheitshinweise

with STF (standard tension force) may be used for friction lashing.
HG00921A:
j Place the lashing strap around the load
Open the ratchet handle
j
webbing can be inserted into it (see Fig. A III).
4
j Insert the webbing
the slotted shaft
j Tighten the lashing strap by moving the handle
forwards (see Fig. A I - III). Tighten the lashing strap until you have obtained the tension
you wish to have.
note: Make sure that webbing
times around the slotted shaft
j Bring the ratchet handle
secure.
HG00921B:
j Use the S hook to securely attach the lashing strap to the load.
Open the ratchet handle
j
webbing can be inserted into it (see Fig. A III).
4
Insert the webbing
j
the slotted shaft
j Tighten the lashing strap by moving the handle of the ratchet backwards and forwards (see
Fig. A I - III). Tighten the lashing strap until you have obtained the tension you wish to have.
note: Make sure that webbing
times around the slotted shaft
Bring the ratchet handle
j
HG00921C:
Loop the lashing strap around the load.
j
j Press the clamping lock
from below (see Fig. C).
Carefully pull the webbing
j
want. Then release the clamping lock

Releasing the lashing strap

Q
CAUTIon! Check before releasing the strap that the load is stable. Make sure that
the load is stable even without the lashing strap and that it cannot fall down.
CAUTIon! RISk of InJURY! Make sure that nobody is near the load when you
release the lashing strap. Falling parts could cause injuries.
CAUTIon! RISk of InJURY! When opening the lashing equipment, the preload
and place the slotted shaft
1
into the slotted shaft
4
until the webbing
3
4 is wound at least 1.5 times to a maximum of 3
.
3
into the basic position (see Fig. A I). The load is now
1
and place the slotted shaft
1
4 into the slotted shaft
until the webbing
3
is wound at least 1.5 times to a maximum of 3
4
.
3
into the basic position (see Fig. A I). The load is now secure.
1
down and pass the webbing
5
through the clamping lock until you get the tension you
6
into the position so that the
3
of the ratchet. Carefully pull it through
3
lies snug against the load.
4
of the ratchet backwards and
1
3
3 of the ratchet. Carefully pull it through
lies snug against the load.
4
6
.
5
into the position so that the
through the clamping lock
GB 11