Ikra BHT 60 Gebrauchsanweisung Und Originalbetriebsanleitung Seite 43

6) Press the throttle control lever right down.
Fig.11
9
Fig.12
Fig.13
7) Pull the starter grip completely as many
as 3 times (fig. 13).
8) Push the choke lever down
part. 9).
9) Pull the starter cable (fig. 13) until the
engine starts.
3 5
4
(fig.12
OPERATING MANUAL
Attention! Do not pull out the starter
rope too far! (Rope length is about
90 cm.)
CAUTION - DANGER !! The engine
starts and accelerates causing the
blades to move.
Let the engine run with the lever pressed for
a few seconds.
10) Release the throttle lever. The engine
will return to idle and the blades will stop
moving.
STOP ENGINE
1) To stop the engine, shut the power switch
(fig. 11 part. 3) "OFF".
CAUTION! Familiarise yourself with
the operation of the throttle lock in
order to act quickly in case of an
8
emergency.
CAUTION! The blades continue to
move for a while after the throttle
lever is released.
WARM ENGINE STARTUP
Follow the instruction given for cold engine
startup, but with the choke lever in position
.
7. OPERATION
Always grip the machine with both hands.
Operate by opening the throttle lever to
maximum.
CUTTING THE TOP OF THE HEDGE
A) Keep the machine in a horizontal position
(fig. 3).
B) The rear handle in a vertical position.
C) For safety reasons, do not use the ma-
chine above shoulder height.
CUTTING THE SIDES OF THE HEDGE
A) For a vertical cut, move the rear handle
GB
GB-4