LENCO PDR-060WD Benutzeranleitung Seite 13

What can you do if you do not have direct DAB+ reception.
•
Always point the antenna straight up vertically first.
•
Do not place the radio too close to potential sources of interference such as,
battery chargers, rotating machinery, computers, large metal surfaces, etc.
•
Move the radio a few meters.
•
Turn on the radio and activate a full scan in the DAB+ menu
•
In the display of the radio you will see the progress of the scan and the number
of stations found in the current position of the radio.
Important
•
With DAB+ reception, there can be a very big difference in reception level
between one location and "a few meters away". In case of a local weak DAB+
signal, move the radio to find a stronger signal.
•
If you take the radio to another location, perform a full scan again. This will
show you which DAB+ stations can be received there.
FM Radio
1. Press the MODE.LUM button to switch to FM mode.
2. Press and hold the SCAN button for 2~3 seconds to start automatic searching
for FM radio channels. Available channels will be stored after the search is
completed. Scan Setting: Press and hold the MENU•INFO button for
2~3 seconds to enter menu set up list. Rotate the TUNE knob to select
"Scan Setting", press the ENTER button to confirm and enter. Rotate the TUNE
knob to select All stations/Strong stations, and press the ENTER button to
confirm. If select All stations, all available channels will be stored after the
search is completed. If select Strong stations, only strong signal radio stations
will be stored after the search is completed.
3. Press the PRESET button to go to the stored Radio station list, then rotate the
TUNE knob to select the desired station and press the ENTER button to play.
You also can press the Shortcut button 1/2/3 to go to preset list radio station
1/2/3 directly.)
4. Rotate the TUNE knob to adjust radio frequency by 0.05MHz at a time. Rotate
the TUNE knob and hold it for 3 seconds to start automatic searching for
next/previous radio station.
5. Long press the PRESET button to add current radio station to the radio list,
rotate the TUNE knob to select list number you want to use, then press the
ENTER button to confirm. You also can press and hold the Shortcut button
1/2/3 to add current radio station into the preset list 1/2/3.
13