Environmental Protection; Maintenance And Repairs - Ryobi BCL14181H Bedienungsanleitung

EN
FR DE ES IT NL
CHARGING A BATTERY PACK
If the charger does not charge the battery pack under
normal circumstances, return both the battery pack and
charger to your nearest authorized service center for
electrical check.
provided.
Make sure the power supply is normal household
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
charger before beginning operation.
Place the battery pack in the charger, aligning the
raised rib on the battery pack with the groove in the
charger.
Press down on the battery pack to be sure contacts
on the battery pack engage properly with contacts in
the charger.
NOTE:
remain on until the battery pack is removed from the
charger or charger is disconnected from the power supply.
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
Do not place the charger and battery pack in an
area of extreme heat or cold. They will work best at
normal room temperature.
NOTE: The charger and battery pack should be placed
in a location where the temperature is more than 10°C
but less than 38°C.
When batteries become fully charged, unplug the
charger from the power supply and remove the battery
pack.
To remove the battery pack from the charger, depress
the latches on each side of the battery pack.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting
to recharge.

MAINTENANCE AND REPAIRS

Risk of injury
Service, testing and repairs should only be
carried out by authorised service centres.
We recommend our customer service department
or authorised service centres.
PT DA SV FI NO RU
English
PL CS HU RO LV LT
STORAGE
Store your charger in a cool dry place between 10 and
It is not recommended to leave it in a cold works van
overnight. Ensure no metal filings or swarf can fall into
the vents during storage, as this may cause serious injury
when it is next used.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety alert
Ukrainian mark of conformity
Please read the instructions carefully
before starting the machine.
Indoor use
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
retailer for recycling advice.
3
ET HR SL SK BG UK TR EL