Jung FRWM200SW Betriebsanleitung Seite 70

there may be no wireless connection. To trou-
bleshoot, proceed as follows:
(1) Check the distance between the de-
vices; reduce the distance if necessary.
(2) Put the devices and radio group into
operation again.
f Restore factory defaults of all devices
(see chapter 10 „Restoring factory
defaults" on page 64).
f Put the devices and radio group into
operation again (see chapter 6 „Initial
commissioning and setting up" on
page 59).
Defective connection test Defective connection test
of a radio group of a radio group
A defective device can be identified within a
radio group by "group connection test" (see
chapter 9.1 „Radio group connection test" on
page 63). If a faulty device is identified, pro-
ceed as follows to troubleshoot
f In order to exclude a temporary radio
interference from other radio-based
devices, perform group connection test
on another device.
5 Connection test was successful and all
devices are operational.
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
70
or
5 Connection test was not successful, there
is a defective device in the radio group.
f Reset the defective device to factory set-
tings (see chapter 10 „Restoring factory
defaults" on page 64).
f Remove the defective devices allocation
to the radio group (see chapter 10.1
„Cancelling a device from a radio group"
on page 65).
f Re-connect radio group with a reduced
number of devices (see chapter 10.1
„Cancelling a device from a radio group"
on page 65).
To add a replacement device to the radio
group, refer to the following chapters:
f Chapter 7 „Expanding radio group and
learning mode" on page 62.
f Chapter 6.2 „Completing radio group"
on page 61.
EN