Jung FRWM200SW Betriebsanleitung Seite 61

5 Device max. 10 minutes in learning
mode.
To add a fur ther device, proceed as follows:
(5) Push the splint pin sideways off ctivation
button.
The devices connect automatically.
(6) Push activation button flush.
Short acoustic signal
5 The device has successfully connected.
(7) To add additional devices, repeat steps
(5) and (6) on each further device.
5 With each newly added device, the learn-
ing mode starts a new 10 minute period.
6.2 Completing radio group
To end the learning mode of a radio group,
you have two options:
f Wait 10 minutes (learning mode ends
automatically) or
EN
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
f Press the radio button briefly on any
device:
Signal LED "off"
5 Radio group is in operation.
Signal LEDs of all the radio
group participants also go out
f To verify, perform the connection test
(see chapter 9.1 „Radio group connection
test" on page 63).
61