Jung FRWM200SW Betriebsanleitung Seite 57

(3) Press firmly magnetic carrier for about 10
seconds at the mounting position.
(4) Taking the device into operation and
setting up.
f Observe chapter 6 „Initial commissioning
and setting up" on page 59.
(5) Put the device on the magnetic carrier.
5 The device is mounted on the magnetic
carrier.
The ultimate strength of the adhesive
bond is achieved after about 72 hours.
Adhesive mounting according to EN Adhesive mounting according to EN
14604:2005/AC:2008 and vfdb 14/01 (Q) 14604:2005/AC:2008 and vfdb 14/01 (Q)
To establish a permanent connection between
the device and magnetic carrier (e.g., as theft
protection), you can additionally mount the
device with the supplied adhesive film on the
magnetic carrier.
EN
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
CAUTION
Possible property damage!
The mounting of the device according
to vfdb 14/01 (Q) establishes a
permanent connection between the
mounting surface and the device. Thus,
a subsequent removal of the device
is prevented. The start-up and set up
of the device are no longer possible. If
the device is disassembled, it can cause
damage to the device and the mounting
surface.
f Use the additional adhesive film
only to prevent theft.
f Put the device in operation and
set it up before attaching the
additional adhesive film.
When performing this type of installation, pro-
ceed as follows:
(1) Mount magnetic carrier.
f Observe chapter „Adhesive mounting
according to EN 14604:2005/AC:2008"
on page 56.
57