Installation; Adhesive Mounting - Jung FRWM200SW Betriebsanleitung

5 Installation

The device is held by a magnetic carrier at the
installation location.
The magnetic carrier can be mounted by glu-
ing or drilling.
It is imperative to observe the instructions in
this manual and the general safety instructions
in order to prevent injuries caused by incor-
rect installation.
CAUTION
Possible property damage!
Using other fastening material (not
enclosed) or wrong conditions at the
installation location can cause the
device to fall down.
f Use only the supplied mounting
material (adhesive pad or screws /
dowels).
f Ensure that the mounting location is
strong enough, solid, dry, free from
grease, dust and loose paint etc.
f Note that the magnetic carrier
magnetically attracts only from
one side.
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
56

5.1 Adhesive mounting

The magnetic carrier can be mounted using
adhesive assembly as follows:
Easy to maintain and removable ac-
•
cording to EN 14604:2005/AC:2008
or maintenance-unfriendly but
•
theft-proof according to
EN 14604:2005/AC:2008
and vfdb 14/01 (Q)
Adhesive mounting accord- Adhesive mounting accord-
ing to EN 14604:2005/AC:2008 ing to EN 14604:2005/AC:2008
When performing this type of installation, pro-
ceed as follows:
(1) Remove magnetic carrier from the
device.
f To do this, tilt the magnetic carrier.
(2) Remove the protective film from the
adhesive pad on the magnetic carrier.
EN