Connecting The Fm And Am Antennas; Connecting The Power Cable; Turning This Unit On And Off - Yamaha RX-V765BL Bedienungsanleitung

Connections

Connecting the FM and AM antennas

An indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Indoor FM antenna
Outdoor AM antenna
Connect a 5 to 10 m vinyl-
covered wire, and extend
it outdoors (use the AM
loop antenna together
with this antenna).
PHONO
S.VIDEO
COMPONENT
VIDEO
P
R
GND
P
B
VIDEO
Y
Ground (GND terminal)
The GND terminal is not for earth grounding.
To reduce noises, connect a ground bar or a
vinyl-covered wire with a copper plate at its tip,
and place it in the moist ground.
y
• The supplied antennas are normally sensitive enough to obtain good
reception.
• Position the AM loop antenna away from this unit.
• If you cannot get good reception, we recommend that you use an outdoor
antenna. For more details, consult the nearest authorized Yamaha dealer
or service center.
• Always use the AM loop antenna even when the outdoor antenna is
connected.
Assembling the AM loop antenna
Connecting the AM loop antenna
The wires of the AM loop antenna have no polarity. You
can connect either wire to the AM terminal and the other
to the GND terminal.
Press and hold
20
En
AM loop
antenna
ANTENNA MONITOR OUT
COMPORNENT
UNBAL. VIDEO
REMOTE
GND AM
FM
P
R IN
OUT
VIDEO
P
B
Y
12V
0.1A MAX.
TRIGGER OUT
Insert Release

Connecting the power cable

After all connections are complete, plug the AC power
cable of this unit into an AC wall outlet.
/PRESENCE
FRO

Turning this unit on and off

1
Press AMAIN ZONE ON/OFF (or
pPOWER) to turn on this unit.
2
Press AMAIN ZONE ON/OFF (or
pPOWER) again to turn off this unit
(standby).
y
• This unit needs a few seconds until ready to play back.
• You can also turn on this unit by pressing MSCENE (or iSCENE).
• This unit consumes a small amount of electricity even during standby.
We recommend disconnecting the power cable from the AC wall outlet.
Caution
Do not unplug this unit while it is turned on. Doing so
may damage this unit or cause the settings of this unit
to be saved incorrectly.
To the AC wall outlet
Power cable