Changing The Calibration Board Retainer Y - Bosch DAS 3000 Reparaturanleitung

1
(1) Countersunk bolts for camera beam mountings
(2) Camera beam
9. Remove the two loose hammerhead nuts from the lower profile slot in the camera beam.
10. Secure the removed countersunk bolt to the camera beam mountings by means of hammerhead nuts.
11. Place the new camera beam on the camera beam mountings so that the hammerhead nuts are located in the
lower profile slot.
12. Tighten the countersunk bolts.
 The hammerhead nut rotates and seats itself securely in the lower profile slot.
 The camera beam is attached to the mountings.
13. Insert the adapter plate with the camera with mini USB socket down into the camera beam.
— Ensure that the cameras are fastened in the same position from which they were removed.
14. Fasten the adapter plate to the camera beam by means of screws.
15. Install the USB cables in the rear profile slot in the camera beam.
16. Connect the USB cables to the cameras.
17. Fasten cover profiles in the rear profile slot so that the USB cables are protected.
---
3.5

Changing the calibration board retainer Y

1. Remove the front cover
(1) Front cover
(2)
2. Remove the rear cover
Robert Bosch GmbH
2
(1)
from the edge protection frame.
1
from the edge protection frame.
DAS 3000 | 31 | en
1 689 975 292 | 2020-02-28