Checking The Calibration Board Retainer Y; Checking The Edge Protection Frame - Bosch DAS 3000 Reparaturanleitung

en | 26 | DAS 3000
2.6

Checking the calibration board retainer Y

1. Secure the DUAL -Board in the D-position.
2. Secure the DUAL -Board with the calibration board retainer Y.
3. Place the electronic spirit level on the DUAL -Board and check for inclination.
Maximum inclination to the DUAL -Board: < 1°
4. Replace the calibration board retainer Y if the measured inclination ≥ 1°.
(1) Electronic spirit level
(2) DUAL -Board
---
2.7

Checking the edge protection frame

(1)
1. Secure the adapter for the electronic spirit level at the top and bottom of the left, center and right braces of
the edge protection frame.
2. Place the electronic spirit level
— Using the clamp screw (3), set the edge protection frame to 90° if the inclination is not 90°.
3. Place the electronic spirit level
4. Check the inclination at the right brace on the edge protection frame.
Max. difference in inclination between right and center brace: ≤ 0.6°
1 689 975 292 | 2020-02-28
(2) (1)
on the adapters at the center brace.
(2.1)
on the adapters at the right brace.
Robert Bosch GmbH