I/O Connector; I/O Connector Pin Assignment - Sony MG10-P1 Bedienungsanleitung

6-2. I/O Connector

In addition to the RS-232C command, data can be output and the
operations performed through the I/O connector.
Wire the I/O connector to the 7-pin connector provided and connect
it to the main unit.

6-2-1. I/O Connector Pin Assignment

32
(E)
No. I/O Pin
7 – Output Common Output signal common pin
6 O Alarm
5 – Input Common
4 I Start/latch input
3 I Pause input
2 I RS trigger input
1 I Reset input
Description
(P1: _COM/P2: +COM)
Alarm output
Input signal common pin
(P1: +COM/P2: _COM)
When the start function is selected
as the input setting: the peak value
updating starts as soon as the
input signal is supplied;
when the latch function is selected:
while the input signal is supplied,
the value is compared with the
current value and the comparator's
result is latched.
While the input signal is supplied,
the updating of the peak value is
temporarily stopped.
The data of all the channels at the
time when the input signal is
supplied is latched and output from
the RS-232C port.
When a link connection is used to
connect more than one unit, all
data from the input unit and units
connected below it is output from
the RS-232C port.
All the channels are reset.
MG10-P1 / MG10-P2