Connecting The I/F Module - Sony MG10-P1 Bedienungsanleitung

3
Secure the counter module using the top and bottom slide locks.
4
Repeat steps 2 and 3 to install all the counter modules, and
then fit the rubber cover, which was removed in step 1 above,
over the counter module connector which was installed last.
<When removing the connected counter modules>
Follow steps 1 to 4 above in reverse. Before removing the modules,
do not forget to release the slide locks.
MG10-P1 / MG10-P2

3-2. Connecting the I/F Module

Only one I/F module can be connected.
1
Use a screwdriver or other tool to remove the cover mounted
on the left side panel of the main module.
n
Take care not to let dirt or metal fragments enter the inside of
the main unit.
7
(E)