Details Of Functions; Peak-Hold; Preset; Reference Point - Sony MG10-P1 Bedienungsanleitung

4-2. Details of Functions

For details on the settings and inputs, refer to chapters 5 and 6.

4-2-1. Peak-hold

The MG10 holds the peak values at all times.
The peak values are checked by switching between the measuring
modes.
The start function makes it possible to restart measurement from
an optional position.

4-2-2. Preset

When the reference point is not used (factory setting)
When the preset value recall input is supplied, the preset value which
has been set is set to the current value.
When the reference point is used
In this case, the function uses the master preset value (refer to the
reference point specifications). When the master value is supplied
as the preset value input after the reference point has been loaded
for the first time, the distance from the master value (preset value)
to the reference point is calculated, and the reference point offset
value is generated internally and stored.
After the reference point has been loaded for the second and
subsequent times, the reference point offset value is automatically
loaded, which means that the preset value need not be input for the
second and subsequent times.
MG10-P1 / MG10-P2

4-2-3. Reference Point

When the reference point is not used (factory setting)
After the power is turned on, the measuring mode is established
automatically.
(Incremental operation)
When the reference point is used
After the power is turned on, the unit automatically enters the
reference point signal input wait status, and then automatically enters
the measuring mode when the reference point is passed.
n
This can be used only when using a measurement unit with a
reference point.
[How to set the reference point (For DK series)]
1
Turn on the power.
The reference point lamp of the counter module starts flashing.
13
(E)