Bosch BPT-S Hybrid Installationsanleitung Seite 250

106 | External cabling
Storage system | Installation manual
6. Secure each of the cables connected with two
cable ties on the strain relief under the terminal
strip
7.3: Strain relief
7. Connect the energy meter: Connect the RS485
cable to RS485 on the storage system housing
The energy meter and the RS485 plug are included
in the scope of delivery.
CAN
V-CAN Open LAN
7.4: Terminals on the storage system housing
PIN Configuration, see the back of the meter cover
for wiring diagram
5 Ground - Ground (27) on the energy meter
3 + (terminal B (24) on the energy meter) 120 Ω
between A and B on the energy meter
8 - (terminal A (23) on the energy meter)
8. Connect the RS485 cable to the energy meter
9. Connect the terminating resistor to the V-CAN
terminal on the storage system housing (on
delivery of the storage system, a terminating
resistor is inserted in this terminal.)
RS485 USB
Bosch Power Tec GmbH
English
USB