Werbung
Always keep the plunge saw clean. Clean the plunge saw after every use with
a dry cloth or compressed air. Do not use any aggressive chemicals for
cleaning.
Changing the Carbon Brushes
The saw is equipped with self-isolating special
brushes. They are automatically isolated when
worn, and the tool stops. Check the carbon
brushes regularly. Replace the carbon brushes
with genuine spare parts if they are worn to the
wear limit (approx. 50% of the block). Always
replace the carbon brushes in pairs.
Cutting Precision fine Adjustment
The cutting precision for straight cuts (90° cuts)
is factory-set. If the cutting precision has come
out of adjustment use a 3 mm hex key to adjust
the stud screws at the bottom of the base plate
to restore the cutting precision.
1. Use a setsquare to adjust the saw blade to
the 90° angle.
2. Lay the plunge saw to the side and set the
cutting precision with the stud screws.
The cutting precision for straight 45° mitre
cuts is factory-set.
1. Swivel the plunge saw to 45° position to
set the 45° mark arrow (see circle).
2. Use a setsquare to check the angle.
3. Lay the plunge saw to the side and set
the cutting precision by means of the
stud screws.
All manuals and user guides at all-guides.com
Operation
43
Werbung
