Werbung
Connecting Rods for the Guide Rails (optional)
1. To connect both guide rails
slide the first connecting rod
from the bottom into the
groove of the guide rail.
2. Slide the other connecting
rod into the second groove.
3. Use the 3 mm hex key to
tighten the stud screws to
the limit stop to connect the rails.
Determining the Cutting Line
When using the saw with guide rail always
A
align position
(0 mark on base plate) at the
front of the base plate with your marked
cutting line for straight cuts and 45° mitre
cuts.
Guide Rail Splinter Guards
The guide rails come with a splinter guard (black protruding rubber lip). The
splinter guard should be cut to size before first use. The splinter guard ensures
a tear-free cut, since the wood fibres at the top of the work piece are torn
without splinter guard. This is due to the saw blade teeth being directed
upward.
After cutting the splinter guard to size it also shows the
precise cutting path of the saw blade.
1. Mark a cutting line on the work piece and align the
guide rail exactly with this cutting line.
2. Fix the guide rail with clamps on the work piece.
3. Set the selector switch to marked cut function. Set
the plunge saw speed to 6.
4. Place the plunge saw at the rear end of the guide rail.
5. Switch the plunge saw on and push the saw down. Cut the splinter guard
continuously over the entire length. The edge of the splinter guard now
exactly matches the cutting edge.
All manuals and user guides at all-guides.com
Operation
A
41
Splinter
Guard
Werbung
