Werbung
All manuals and user guides at all-guides.com
Operation
Before the first Use
Remove the plunge saw and the accessories from the packaging. Check the saw
for transport damage and do not use the saw in case of damages. Keep the
packing materials away from children, risk of suffocation!
Contents of the Package
1x Plunge Saw
1x TCT Blade 48 Teeth
1x Hex Key 5 mm
1x Set of Replacement Carbon Brushes
1x User Manual
Intended Use
The plunge saw is intended to cut wood and similar materials, gypsum and
cement-bonded fibre materials and plastics. With suitable, specialised saw blades
the plunge saw can be used for cutting Aluminium.
The plunge saw is only to be used with a specifically designed guide rail.
Installation in a different or homemade guide rail or workbench can cause serious
accidents.
Plunge Saw Features
The plunge saw comes with solid shaft electronics with following features:
Soft Start: The electronically controlled soft start ensures a start of the plunge saw
without kickback.
Thermal Fuse: The saw is equipped with a thermal fuse to protect against
overheating (motor burn-out). The protection circuit turns the motor off before
reaching a critical motor temperature. After cooling down for approx. 3 – 5
minutes the plunge saw is again ready to use and fully operational. In idle speed
the cooling period of the plunge saw is considerably reduced.
Current Limitation: The current limitation prevents too high current draw during
extreme overload. This can cause reduced motor speed. After load relief the
motor starts up again immediately.
Constant Speed: The preset motor speed is electronically kept. This allows for
continuous cutting speed even under load.
Selector Switch: Use the selector switch (20) to set the respective operation
mode.
32
Werbung
