Werbung
Change Saw Blade
Plunge Cut
Marking Cut
Speed Setting: The speed regulator (4) allows
setting the motor speed infinitely variable between
2000 and 5300 min-1. The cutting speed can be
optimal adjusted for the respective materials. Turn
the speed regulator (4) towards 1 to reduce the
motor speed; turn the adjusting wheel towards 6 to
increase the speed.
The respective motor speed depends on type and
thickness of the work piece. Observe directions below for cutting uniform
materials with the appropriate speed:
Speed Range 1 – 3:
Speed Range 4 – 5:
Speed Range 5 – 6:
Notes: At higher speed settings you cut the material faster, but this reduces the
life cycle of the saw blade.
Reduce the speed for clean cuts in heat sensitive and soft materials.
Do not use the speed regulation to use saw blades for lower nominal speed. Only
use saw blades with a minimum speed of 5300 rpm.
Switching the Plunge Saw ON and OFF
1. Press the switch lock (1) and then the ON/ OFF switch (2) to switch the plunge
saw on.
2. Release the ON/OFF switch (2) to switch the plunge saw off.
Notes: Pressing the switch lock (1) unlocks the plunge cut mechanism at the
All manuals and user guides at all-guides.com
Operation
Gypsum and cement-bonded fibreboard, plastics (soft),
non-ferrous metals
Plastics (hard), fibre-reinforced plastics (GRP), paper and
fabrics, particle and hard boards, acrylic glass (Perspex)
Solid wood (hard, soft), plywood, core boards, veneered
and coated boards, plastic-coated boards, MDF boards
33
(4)
Werbung
