Maintenance - Ferm BLM1002 Gebrauchsanweisung

Besides, in the table - second column- is mentioned how
the starting size by means of the same change wheels can
be adjusted.
Inch
n/inch A B C
48 70 79
40 70 84 79
32 105 98 49
24 98 40
20 70 84 40
16 56 84 40
14 49 105 50
12 49 98 40
11 49 105 39
8 50 105 28
Tab.5
12

MAINTENANCE

Make sure that the machine is not live when
carrying out maintenance work on the benchlathe
LUBRICATING SCHEDULE
Fig.18
Part Time/interval
Lubricant
Roller bearing After first 10 days Transmission oil
main shaft SAE90:
Bearings and cog after 20 days and till sight-glass is half
wheels of speed then each 60 days full(1) or lowest cog
reduction axles in wheels just in the
the headstock (2) oil
Bearings V-belt
roller and axle Annually The same
mediate
Thrust bearing
mission (13) Annually Universel gear
Change gear
wheels (12) At change or The same
Gear wheels lock Weekly
with gear Weekly Fine lubricating oil
rack(15)
Gear wheel
bearings lock Daily The same
case, lock nut
mechanism (17)
Transmission/
starting axle (18) The same The same
Sliding surfaces
off the bed (3) The same The same
Support spindles
(8, 16) The same The same
All ball nipples
the (5,6,9,14 and The same The same
20)
Felt in chips
bulldozers (4) The same
All remaining
white parts Weekly Vaseline
without cover
layer
Tab.6
Maintenance of the machine happens for preventing rust
and wear end tear. The maintenance consists mainly of
clearing and oiling. It certainly is not sufficient to handle
only the oil-syringe. Chips and waste of the machine
parts have to be removed very regularly, often more
times during turning. Otherwise there is the possibility it
lands between moving, slipping and turning parts. For
this reason chips bulldozers on the cross slide have been
placed. watch fig.18.
Ferm Ferm 65