Rc Functions - XciteRC Rocket 250 3D Bedienungsanleitung

Now switch the transmitter on (5). Move the left throttle lever all the way up and then back in the lowest
position (6). This safety circuit prevents the rotor may start after turning ON the Quadrocopter.
• The model is ready to fly as soon as a short beep is heard. The POWER LED of the transmitter and the
EN
Quadrocopters LED lights up solid.
• Note: when the model is not used for about 30 seconds, it automatically switches back to the bind
mode, the LEDs starts to flash. To fly, the throttle must once again moved all the way up and then back
in the lowest position
• GYRO CALIBRATION: before the first flight the gyro must be calibrated. Move both control levers
downwards to the left (4) and hold until all LEDs flash briefly. This is also necessary if the model flies badly
e.g. after a crash.
• MODE SELECTION: to select the control mode 1 or 2 (see chart RC functions), switch the trans-
mitter off and press the right trim lever. Now switch on the transmitter again (5).
• If the flight battery runs low, the LEDs on the motor mounts starts flashing. From now on the model is con-
trollable for one more minute only. Find a suitable landing spot and land. Charge the flight battery again.

RC functions

Mode 1 (factory setting)
20
1 2
Mode 2
RC functions
XciteRC Rocket 250 3D