Defrosting Of The Appliance; Periods Of Non-Operation; Troubleshooting - Electrolux TG90N Benutzerinformation

7.3 Defrosting of the appliance

The defrosting of the freezer compartment is
automatic. Although, a layer of frost may
occur on the freezer compartment's interior
walls if the freezer door is opened frequently
or kept open too long.

7.4 Periods of non-operation

When the appliance is not in use for long
periods, take the following precautions:

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The compressor operates continual‐
ly.
The compressor does not start im‐
mediately after pressing the "Super
Freeze", or after changing the tem‐
perature.
Door is misaligned or interferes with
ventilation grill.
68 ENGLISH
1. Disconnect the appliance from electricity
2. Remove all food.
3. Clean the appliance and all accessories.
4. Leave the door open to prevent
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put in at
the same time.
The room temperature is too high.
Food products placed in the appli‐
ance were too warm.
The door is not closed correctly.
The Super Freeze function is
switched on.
The compressor starts after a period
of time.
The appliance is not levelled.
supply.
unpleasant smells.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli‐
ance to the mains socket. Contact a
qualified electrician.
Check if the appliance stands sta‐
ble.
Refer to the "Operation" chapter.
Wait a few hours and then check the
temperature again.
Refer to the "Installation" chapter.
Allow food products to cool to room
temperature before storing.
Refer to the "Closing the door" sec‐
tion.
Refer to the "Super Freeze function"
section.
This is normal, no error has occur‐
red.
Refer to the installation instructions.