Getting Started; Basic Settings - Hama Mini Bedienungsanleitung

4. Getting started

Warning
• Only operate the product from an approved
socket that is connected to the public power
supply. The socket must be installed close to the
product and must be easily accessible.
• Disconnect the product from the power supply
using the On/Off switch – if this is not available,
unplug the power cord from the socket.
• If using a multi-socket power strip, make
sure that the total power consumption of all
connected devices does not exceed the socket
strip's maximum throughput rating.
• If you will not be using the product for a
prolonged period, disconnect it from mains
power.
Plug the timer into an approved and easily accessible
wall socket to charge the integrated battery. If you want
to make the settings immediately, leave the timer in the
socket. If the display does not show anything, press the
reset button (9)
Note
• There is a rechargeable battery in the unit. This
ensures that the time continues to run even if
the timer is not connected to a socket.
The times already programmed also remain
stored.
• When not used for a prolonged period, the
internal battery will discharge. Plug the
timer into an electric socket for approx.
24 hours every 3 months to charge the
internal battery.

4.1 Basic settings

Note - Basic settings
Note that these basic settings are only possible
while the current time is displayed. If the timer is in
programming mode, press the CLOCK button (2) to
switch to the display of the current time.
12/24-hour format
Press and hold the CLOCK button (2) until the time
indication on the display changes to the desired
time format.
First half of
Time display
the day
Weekday & time
• Press and hold the SET button (6) until the day of
• Set the following information in sequence:
• To select the individual values, press the + button
Summer / winter time
• Press the CLOCK button (2) and the V- button (8)
• The time is advanced by one hour and S appears
• Press the CLOCK button (2) and the V- button (8)
• The time is set back one hour and S on the display
4.2 Programming
You can program up to 20 programs (1 - 20) with
separate ON and OFF times at which the connected
terminal is switched on or off.
• Press the +button (7) to switch from the current
• Press the +button (7) repeatedly to switch between
• Sequence: 1ON à 1OFF à 2ON à...à 20ON
• Alternatively, press the V- button (8) to switch
• When the desired program - e.g. 3ON - is displayed,
Second half
of the day
• Set the following information in sequence:
12-hour
format (with AM 00:00 -
AM/PM 11:59
display)
24-hour
format 00.00 –
(without 11:59
display)
the week indicator in the upper part of the display
starts ashing.
Current day of the week (Mon, Tu, We, Th, Fr, Sa, Su)
Hours (Current time)
Minutes (Current time)
(7) or the V– button (8) and con rm the selection by
pressing the SET button (6).
simultaneously to activate summer time.
on the display.
again simultaneously to deactivate summer time or
activate winter time.
goes out.
time display to the programming mode.
1ON is shown on the lower left side of the display.
the programs and their on and off times.
à 20OFF à
d ON / d OFF à Display current time à 1OON
à 1OFF ...
between the programs in reverse order.
press the SET key (6) until the day of the week
display starts ashing.
PM 12:00 -
11:59
12.00 –
23:59
3