Install The Pedals; Saddle Height Adjustment - HONBIKE U4 Benutzerhandbuch

Install the pedals

20~25Nm
20~25Nm
Apply some anti-rust oil or grease on the pedal threads if necessary.
11
H6
Right:
Take the right pedal with the label R.
Screw it clockwise onto the crank by
hand. Use Hex Key #6 to tighten it.
Left:
Take the left pedal with the label L.
Screw it anticlockwise onto the
crank by hand. Use Hex Key #6 to
tighten it.

Saddle height adjustment

1. Use Hex Key #5 to loosen the clamp bolt
anticlockwise until the saddle can be moved
Be careful not to loosen this bolt too much.
2. Lift the saddle upward to an appropriate
height.
2
10
9
When you see the "Minimum Insertion"
1
8
7
warning mark, the saddle has been raised
MIN.INSERTION
6
to its highest position.
5
4
3
2
1
MIN.INSERTION
13~15Nm
3. Tighten the bolt clockwise with Hex Key #5.
EN
H5
12