Install The Front Fender; Install The Front Wheel - HONBIKE U4 Benutzerhandbuch

Install the front fender

1. Take out the front fender and attach it to
the front fork, as shown on the left. Loosely
B C
tighten the three M5 bolts to the front fork in
the order of ABC.
Do not fully tighten for subsequent adjustment
of position.
A
6~8 Nm
2. Firmly tighten each bolt in the order of
B C
ABC in the arrow direction until all bolts are
secured.
Make sure that the front fender is not skewed or
tilted. Make sure it does not shake at the center
of the front fork.
A
7
H3
The fender can move up
and down in a small scope.

Install the front wheel

1. Hold on to the middle part of the axle tightly
with one hand, and loosen the axle nut on any
side anticlockwise with a socket spanner.
Remove the axle nut, washer, and axle and set
them aside for later use.
The axle nut and washer on the other side can
be removed with the axle. You don't have to
loosen them.
2. Remove the plastic guard that protects the
brake disc. Put the front wheel into the front
fork. Make sure the brake disc is aligned with
the brake pad.
EN
brake pad
brake disc
brake disc
brake pad
8