Adjust The Right Brake Lever - HONBIKE U4 Benutzerhandbuch

3. Install the axle on the front fork.
A B
B A The exposed part of the axle shall be about 1.5mm
when the spacer nut is strung on the axle.
3 4
4. Place the washer and nut you removed in
step 1 in sequence.
Please follow the instructions shown in the
diagram. Install the washer first, then screw on
the nut.
35~40Nm
5. Tighten up the nut on the outside clockwise
using the socket spanner.
6. Cover the dropout cover on both sides.
After the front wheel is installed, make sure that the
front fender fits the curvature of the front wheel.
There are 4 dropout covers totally in the tool box,
two for loading and two spare ones.
7. After the front wheel is installed, flip the
bicycle 180 degrees, land it correctly on the
ground and put down the kickstand.
9
1.5mm
It is recommended to operate with two people.

Adjust the right brake lever

The left brake lever of HONBIKE U4 is adjusted at the factory. Please
follow the steps below to adjust the right brake lever.
1. Use Hex Key #5 to loosen the bolt on
5~8Nm
2. Once the bolt is adequately loose,
adjust the brake lever to an appropriate
and comfortable position. Use Hex Key #5
to tighten the bolt clockwise.
EN
H5
The bolt is under the brake lever.
10