Display Advanced Settings - HONBIKE U4 Benutzerhandbuch

Display advanced settings

Enter/exit settings
When the power is on, press the "+" button and the "-"
button at the same time and hold for 3 seconds, to enter the
parameter setting mode;
Setting menu selection: short press "+" button or "- " button
to switch between different parameter settings.
Short press the "power button" to save current parameters
and exit to the setting menu interface.
Long press "-" button to quit the setup mode.
If no operation is carried out within 30 seconds, it will automatically exit
the setting interface, and any adjustments will be automatically saved
P1—Metric/English system switching
When the interface displays P1, the metric unit and
imperial unit can be switched.
Short press the "+" or "-" button to switch between mile
and km.
After the setting is completed, long press the "- " button to
save the setting.
P4—Backlight brightness
When the interface displays P4, the backlight brightness
can be adjusted.
Short press "Power" button to enter or exit backlight
brightness setting interface.
Short press "+ " button or "-" button to set the backlight
brightness.The brightness level is scored from 1 to 3, where 1
means the darkest, and 3 means the brightest.
After the setting is completed, long press the "-" button to
save the setting.
The default backlight brightness is 3.
19
P5—Auto power-off timer
Short press "Power " button to enter or exit automatic power-off
setting interface. Press the "+" or "-" button to switch the
automatic power-off time in minutes. It can be adjusted between
0~9minutes. After the setting is completed, long press the "-"
button to save the setting.
0 means that automatic power off function is disabled.
Fault Indication
In the case of an electronic control system fault, an alarm icon will
be displayed, and the corresponding error code will be flashed in the
speed interface. Please check www.honbike.com for particular error
code meanings and solutions. When the alarm icon and error code
are displayed, you must consider your bike unsafe to ride. Please
stop using it and contact us promptly.
EN
20