Adjusting The Saddle Position And Angle; Recommended Torque Values - HONBIKE U4 Benutzerhandbuch

Adjusting the saddle position and angle

1. Remove the rubber plugs on the
bolts and keep them safe. Use
Hex key #5 to loosen the saddle
adjustment bolts.
2. Once the bolts are adequately
loose, the saddle can be moved
forward or back and angled up or
down.
3. Move the saddle to the desired
position, and tighten the bolts to
20-25Nm. Install the rubber plugs
to protect the bolts.
Do not exceed the maximum limit marking on the saddle rail when you
13

Recommended torque values

H5
1
2
1
2
3
4
5
6
7
8
9
Ensure correct setup, tightening, and torquing to recommended torque values
is performed on your bicycle before first using it and check the setup, tightening,
and condition of components and hardware regularly.
7
9 8
Brake lever bolts 5-8 N·M
Handlebar bolts 13-15N·M
Saddle adjustment bolts 20-25N·M
Saddle clamp bolt 13-15N·M
Rear wheel nuts 35-40N·M
Kickstand bolts 13-15N·M
Pedals 20-25N·M
Crank arm bolts 40-45N·M
Front wheel nuts 35-40N·M
EN
3
4
5
6
Hex Key #5
Hex Key #5
Hex Key #5
Hex Key #5
adjustable wrench
Hex Key #5
Hex Key #6
Hex Key #8
14