Charging Status; Battery Charging - Meec tools 021614 Bedienungsanleitung/Übersetzung Der Originalanleitung

Charging status

Press the button beside the charge indicator to see the charging
status of the battery. Four status lights show that the battery is
fully charged, one status light shows that it is discharged.

Battery charging

NOTE:
• When the battery has been charged for the first time,
make sure that it is fully discharged before charging it
again. Repeat this charging and discharging cycle four or
five times to condition the battery.
• The given times are only intended as guidance.
The charging and discharging time is affected by
the age, condition and use of the battery.
1. Place the battery charger on a level, stable surface. Plug the
plug into an earthed power point with the correct mains
voltage.
2. Connect the battery to the charger and check that it clicks in
place.
3. The status lights for the battery charging status are described
in the table below.
4. Pull out the plug from the power point and take the battery
out of the charger.
EN
37