Battery Charging; Cleaning And Maintenance - Meec tools 019800 Bedienungsanleitung

BATTERY CHARGER
Check that the mains voltage corresponds to
the rated voltage on the type plate.
Check before using the charger that the power
cord and plug are intact and undamaged.
A damaged power cord or plug must be
replaced by an authorised service centre or
other qualified personnel.
Do not expose the battery charger to moisture,
or use it in damp conditions.
The charger must only be used to charge the
supplied batteries.

BATTERY CHARGING

Always connect the charger to the battery first,
and then to the power point.
The battery and charger get hot when
charging. This is perfectly normal.
After charging, pull out the plug first and then
remove the battery from the charger.
STATUS LIGHTS
Red: charging in progress
Green: fully charged
1. Charging status lights
FIG. 1
NOTE:
Pull out the plug before inserting or
removing the battery.
The charger must only be used for charging
rechargeable batteries.
Do not expose the charger to rain or
moisture.
MAINTENANCE
Always remove the battery before doing any
maintenance.

CLEANING AND MAINTENANCE

Clean the charger at regular intervals. Keep the
ventilation openings clean. Clean the casing with
a damp cloth, without solvent, and wipe dry.
IMPORTANT:
Switch off the charger immediately and pull
out the plug if there is a problem during
use. Check and if necessary have the charger
repaired before using it again. Repairs must
only be carried out by qualified personnel.
There is a risk of personal injury if unqualified
persons carry out service or maintenance.
Only use approved spare parts and
accessories for servicing.
IMPORTANT:
Only use the supplied charger.
NOTE:
The battery capacity is reduced during long-
term storage.
To maintain the battery capacity it should be
fully charged before long-term storage and then
recharged at regular intervals. Store in a dry
place and frost-free place at no more than 40°C.
STORAGE
Store the product, instructions and any
accessories in the original packaging. In this
way you always have all the information and
all the parts easily accessible.
Use the original packaging or other suitable
protection during transport.
Store the product in a dry place.
EN
11