Kinderkraft A-TOUR Bedienungsanleitung Seite 29

seat is shown on (PIC. V). To disassemble the adapters from the pushchair's frame, press the lock buttons on each adapter
(PIC.W)
WARNING! The car seat must be always placed on the frame
back to the direction of travel (the child should face the person
pushing the buggy).
VIII USING THE BRAKE The pushchair is equipped with a foot brake for parking located on the rare axle. Press the brake
pedal downwards to activate the brake. Unlocking the break happens by lifting the pedal upwards (PIC.X).
IX DISSASEMBLY OF THE PUSHCHAIR To disassemble the carrycot/seat of the frame, press the buttons located on both
sides, placing your fingers at the bottom of the buttons as shown on (PIC. Y), and lift the carrycot/seat up. After removing
the carrycot/seat or a car seat, turn the cup holder from your direction to the side, pressing the button and simultaneously
pulling the handle on both sides of the frame, and at the end, push the parent handle downwards (PIC.Z). Correctly folded
frame shall be secured with the side lock (PIC.AA). If necessary, the front (PIC.BB) and rear wheels (PIC.CC) can be detached
from the frame after pressing the buttons. There is a possibility to minimise pushchair's dimensions after folding. To do
so, press the buttons on both sides of the frame as shown on (PIC.DD).
X ADJUSTING THE PUSHCHAIR Pushchair's front wheels have the possibility to be locked to ride straight. This mode is
activated by lowering the lock sliders (PIC. EE).
To unlock the front wheels, pull the sliders up.
The shade can be enlarged by unzipping the zip on the outer side of the sheathing (PIC. FF).
To adjust the parent handle, press the lock buttons on both sides of the pushchair and adjust the handle Aby to a
comfortable height (PIC. GG)
The seat angle can be adjusted by a handle located at the top of the backrest (PIC. HH). The seat has 3 positions: lie-flat,
reclining and sitting.
WARNING! For the lie-flat position of the seat, do not unbuckle
the straps at the back of the backrest, this can cause the child's
head to be positioned below the rest of the body
The seat is adjustable, enabling the child to face the parent or the direction of travel. To adjust the seat, press the buttons
on both sides of the seat, flip it over and push it back until you hear a click (PIC.II).
XI SAFETY HARNESS To secure your child, connect the waist and shoulder strap hooks and then slide them into the central
buckle till it locks (PIC. JJ). Adjust the safety harness at all times to secure your child properly.
Begin unbuckling the harness by pressing the button to open the buckle.
For smaller children who cannot independently sit up yet, the straps in the carrycot version should be hidden under the
mattress. The seat/carrycot has attachment points for an additional harness.
Shoulder straps can be fixed at one of two heights.
XII CARE AND MAINTENANCE The buyer is responsible for proper installation of all functional elements as well as for
carrying out all required maintenance and adjustments in order to keep the buggy in good technical condition.
The buggy must be periodically checked for potential problems. Significant measures to be applied to ensure the child's
safety and prevent shortening of the product life have been presented below:
• Check the strength and safety of all rivets and connections.
• Check all wheel locking equipment and tyres. If necessary, replace or repair.
• Check if all safety devices work properly, particularly the main and additional fasteners that should move freely at any
time.
Please, stop using the buggy if there are doubts as to its proper use or a suspicion of any danger.
If the wheels squeak, apply a thin layer of silicone. Do not use oil or grease based products as they attract dirt, which
makes buggy movement difficult.
XIII CLEANING If the elements of the buggy chassis have been exposed to saltwater, rinse with tap water as soon as
possible.
29