Removing Ingredients; Setting The Timer/Alarm; Displaying The Room Temperature - Silvercrest SKWE 5 A1 Bedienungsanleitung

Removing ingredients

You can also use the scales to weigh an amount you take out after the
weighing process (for instance, if have added too much).
1) To do this, reset the scales to 0 by pressing the
The weight display 9 shows g. The tare symbol
2) Remove the ingredient from the weighing bowl 8. The weight of the
removed quantity is displayed as a negative weight. The
appears.
3) Press the
e disappears. The weight display 9 shows g again.
4) You can now add or remove other quantities.

Setting the timer/alarm

You can also use the scales as a kitchen timer. You can set the time from
00:10 seconds to 99:50 minutes in steps of 10 seconds. The timer then
counts down the time. To set the timer, proceed as follows:
1) Once the scales are switched on, press the Timer button
The alarm symbol
2) To set the time, press the
10 seconds each time) or the
10 seconds each time).
3) Press the Timer button
down.
Note: To stop the countdown prematurely, press the Timer button
again. Then press it one more time to reset the timer back to 00:00. The
alarm symbol
4) After the set time has elapsed, you will hear an alarm and the alarm
symbol
Press the ON/OFF button

Displaying the room temperature

When the scales are switched on, the temperature display 0 shows the
room temperature in °C.
SKWE 5 A1
button 5 again to reset the scales to 0. The tare symbol
TARE
appears on the timer display r.
button 5 (the value increases by
TARE
UNIT
T
2 to confirm the set time and start the count-
SET
on the timer display r disappears.
on the timer display r flashes. The LC display 4 goes off.
ON
OFF
TARE
button 6 (the value decreases by
3 to switch on the appliance.
button 5.
e appears.
symbol w
T
2.
SET
T 2
SET
GB │ IE │
9 ■