Intended Use - Makita DUC406ZB Betriebsanleitung

Saw chain type
Number of drive links
Guide bar
Sprocket
WARNING:
Use appropriate combination of the guide bar and saw chain. Otherwise personal injury may result.
Symbols
The followings show the symbols used for the equipment. Be
sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Wear ear protection.
Wear a helmet, goggles and ear protection.
Use appropriate protection for foot-leg and
hand-arm.
This saw is to be used by properly trained
operators only.
Do not expose to moisture.
Maximum permissible cut length
Always use two hands when operating the
chain saw.
Beware of chain saw kickback and avoid
contact with bar tip.
Direction of chain travel
Saw chain oil adjustment
Only for EU countries
Ni-MH
Do not dispose of electric equipment or battery
Li-ion
pack together with household waste material!
In observance of the European Directives,
on Waste Electric and Electronic Equipment
and Batteries and Accumulators and Waste
Batteries and Accumulators and their implemen-
tation in accordance with national laws, electric
equipment and batteries and battery pack(s)
that have reached the end of their life must be
collected separately and returned to an environ-
mentally compatible recycling facility.
Guide bar length
Cutting length
Pitch
Gauge
Type
Number of teeth
Pitch

Intended use

The tool is intended for cutting branches and pruning
trees. It is also suitable for tree service.
Noise
The typical A-weighted noise level determined accord-
ing to EN ISO 11681-2:
Model DUC256
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC306
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC356
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC406
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model DUC256C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual use
of the power tool can differ from the declared value(s)
depending on the ways in which the tool is used espe-
cially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as the
times when the tool is switched off and when it is run-
ning idle in addition to the trigger time).
8 ENGLISH
25AP
60
250 mm
253 mm
1/4"
1.3 mm
Carving bar
9
1/4"
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA
) : 89 dB(A)
pA
) : 103 dB (A)
WA